>  Wireless Mesh Solution
TVWS, 4.9GHz, 5GHz mesh backhaul solutions with 2.4GHz Access Point Switching Wireless Mobile Mesh Network Access Point

Thin/Fit Access Point
Indoor and Outdoor Thin/Fit Wireless Access Point transmission rate up to 300Mbps, support multiple access modes(b/g, b/g/n)

> Wireless Mobile Device
High speed mobile wireless access solution for railway

> Wireless Access Controller 
Carrier-class Core Wireless Controller with the largest capacity up to 2.56T with high-speed ASIC processors chipset. Supports 802.11n, ideally for 3G data Offload for Mobile Service Provider.

> MeshAP Manager
Web (HTML) based GUI Management Tool for MeshAP Access Points


> Downloads
> Product Registration
> Update Request

Technical Support







Home > Technology


- Multiple RF vs. Single RF design
- Multi-Channel
- Predictable Optimum Path (POP)
- High Throughput Mesh Network
- MeshAP Access Point implements Layer 2 mesh routing
- Fully Compatible with Existing Access Server, Router, and Gateway
- Web(HTML) management
- The MeshAP Access Point is highly secured


Multiple RF Design
Many mesh products on the market use single 802.11a radio for backhaul and another 802.11b/g for service(clients). But single 802.11a radio backhaul cannot send and receive data at the same time. Every packet relayed to another node has to be sent twice on the same channel. This compounded repetition on the same channel causes degraded throughput and latency at each hop. The mesh runs out of steam after a few hops.

ArrowSpan’s multi-radio full duplex design (Triple RF: MeshAP 5100/3100 and Dual RF: MeshAP 2180/1100) greatly enhances the throughput and hop counts. This unique design eliminates the single radio performance degradation, and provides even bandwidth distribution over more hops in larger areas.

Single RF Design


> Continue to Predictable Optimum Path (POP)


Copyright ©2006-2015 ArrowSpan, Inc. All rights reserved. Privacy Policy