PRODUCTS

> MeshAP 5100 Outdoor - Dual 5GHz and Single 2.4GHz Full-Duplex Wi-Fi Mesh Access Point

> MeshAP 3100G Outdoor - Dual 5GHz and Single 2.4GHz Full-Duplex Wi-Fi Mesh Access Point with built-in GPS Antenna

>MeshAP 3100 Outdoor - Dual 5GHz and Single 2.4GHz Full-Duplex Wi-Fi Mesh Access Point

> MeshAP 2180 Outdoor - High Performance 2.4GHz Full-Duplex Wi-Fi Mesh Network Access Point

> MeshAP 2100 Outdoor - 2.4GHz Full-Duplex Wi-Fi Mesh Network Access Point

> MeshAP 1100 Indoor - 2.4GHz Full-Duplex Wi-Fi Mesh Network Access Point

> MeshAP Manager Web (HTML) based GUI Management Tool for MeshAP Access Points

SUPPORT

> Downloads
>
Warranty
> FAQ
> Product Registration
> Update Request


Where To Buy

> Online Store


Technical Support
> support@arrowspan.com

Information
> info@arrowspan.com

Webmaster
> webmaster@arrowspan.com

Feedback
> feedback@arrowspan.com

Home > Support > Installation & Configuration

Wireless

Step 1. Login to the MeshAP Access Point.

Note: To access a MeshAP Access Point on the mesh network, login to the Mesh Manager unit, and access the Topology page to locate the MeshAP Access Point unit, which needs configuration.

Step 2. Go to the Wireless page under the AP section.

Wireless Network Mode

Setup Auto Mode

Under Auto Mode, MeshAP Access Points will accept both 802.11b and 802.11g clients.

Step 1. Go to the Basic section.

Step 2. Use the drop down menu to select Auto.

Step 3. Click “Save Settings and Apply” to apply the new setting.

Setup G-Only Mode

Under Auto Mode, the MeshAP Access Point will accept only 802.11g clients.

Step 1. Go to the Basic section.

Step 2. Use the drop down menu to select G-Only.

Step 3. Click “Save Settings and Apply” to apply the new setting.

 

Wireless Channel

Channel/Frequency. This field identifies which operating frequency will be used. It should not be necessary to change the wireless channel unless you notice interference problems or setting up the MeshAP near another access point.

MeshAPs associated with a Mesh Manager unit will automatically calibrate its channel to reduce interference between MeshAPs on the mesh network.

Step 1. Go to the Basic section.

Step 2. Use the drop down menu to select a desired channel.

Step 3. Click “Save Settings and Apply” to apply the new setting.
  

> Back to Installation & Configuration


Copyright ©2006 ArrowSpan, Inc. All rights reserved. Privacy Policy