PRODUCTS

> MeshAP 5100 Outdoor - Dual 5GHz and Single 2.4GHz Full-Duplex Wi-Fi Mesh Access Point

> MeshAP 3100G Outdoor - Dual 5GHz and Single 2.4GHz Full-Duplex Wi-Fi Mesh Access Point with built-in GPS Antenna

>MeshAP 3100 Outdoor - Dual 5GHz and Single 2.4GHz Full-Duplex Wi-Fi Mesh Access Point

> MeshAP 2180 Outdoor - High Performance 2.4GHz Full-Duplex Wi-Fi Mesh Network Access Point

> MeshAP 2100 Outdoor - 2.4GHz Full-Duplex Wi-Fi Mesh Network Access Point

> MeshAP 1100 Indoor - 2.4GHz Full-Duplex Wi-Fi Mesh Network Access Point

> MeshAP Manager Web (HTML) based GUI Management Tool for MeshAP Access Points

SUPPORT

> Downloads
>
Warranty
> FAQ
> Product Registration
> Update Request


Where To Buy

> Online Store


Technical Support
> support@arrowspan.com

Information
> info@arrowspan.com

Webmaster
> webmaster@arrowspan.com

Feedback
> feedback@arrowspan.com

Home > Products

STATION CONFIGURATION

Setup Station in Auto Mode

Note: To access a MeshAP Access Point on the mesh network, login to the Mesh Manager unit and access the Topology page to locate the MeshAP Access Point unit needing configuration.

Step 1. Login to the MeshAP Access Point.

Step 2. Go to Setup page.

 

Step 3. SelectStation” for This MeshAP Working Mode.  

Step 4. SelectAuto” for Mesh Link Connection

Note: The system will reboot when changed from “Manual” mode to “Auto” mode. It takes about 40 sec. and requires re-login to the unit.


 

Step 5. Select Min Mesh Link Signal Strength (Default -70dbm).

Mesh ID

Mesh ID is designed for a Service Provider/Carrier/Operator to uniquely identify its mesh network. Only MeshAP Access Points under the same Group ID will be able to associate with each other on the mesh network.

Step 6. Replace the default Group ID with a preferred group name with the Mesh Manager. MeshAP Stations MUST use the same Group ID in order to be managed by the Mesh Manager unit. 

Step 7. Update Station Name. (Station Name is NOT required, it is recommended for easy identification of each Station.)

Step 8. Update Station Location. (Station Location is NOT required, it is recommended for easy identification of each Station.)

Step 9. Click "Save Settings and Apply" to confirm changes.

Connect a MeshAP Station to other Stations/Mesh managers
under Auto Mode

MeshAP Stations with identical Group ID under the Auto Mode will automatically associate with the Mesh Manager or the Stations on the mesh network. The association will be based on the wireless signal quality and hop counts of the adjacent unit.

Each MeshAP Access Point will only accept up to five (5) child Stations.

Step 1. Power ON the MeshAP Station with Auto Mode.

Step2. Login to the Mesh Manager unit.

Step 3. Review the Topology section to manage the Stations on the mesh network.

Note: The MeshAP Station under the Auto Mode, should automatically associate with the Mesh Manager unit or the other Stations on the mesh network. The only way to make sure the Station is properly associated with the mesh network is to review the Topology in the Mesh Manager. 

 

> Back to Installation & Configuration

Copyright ©2006 ArrowSpan, Inc. All rights reserved. Privacy Policy