PRODUCTS

> MeshAP 5100 Outdoor - Dual 5GHz and Single 2.4GHz Full-Duplex Wi-Fi Mesh Access Point

> MeshAP 3100G Outdoor - Dual 5GHz and Single 2.4GHz Full-Duplex Wi-Fi Mesh Access Point with built-in GPS Antenna

>MeshAP 3100 Outdoor - Dual 5GHz and Single 2.4GHz Full-Duplex Wi-Fi Mesh Access Point

> MeshAP 2180 Outdoor - High Performance 2.4GHz Full-Duplex Wi-Fi Mesh Network Access Point

> MeshAP 2100 Outdoor - 2.4GHz Full-Duplex Wi-Fi Mesh Network Access Point

> MeshAP 1100 Indoor - 2.4GHz Full-Duplex Wi-Fi Mesh Network Access Point

> MeshAP Manager Web (HTML) based GUI Management Tool for MeshAP Access Points

SUPPORT

> Downloads
>
Warranty
> FAQ
> Product Registration
> Update Request


Where To Buy

> Online Store


Technical Support
> support@arrowspan.com

Information
> info@arrowspan.com

Webmaster
> webmaster@arrowspan.com

Feedback
> feedback@arrowspan.com

 

 

Home > Support > FAQ

FAQ

Q: How do I upgrade the firmware on the MeshAP Access Point?

Follow the directions below to upgrade the firmware for the MeshAP 2100/MeshAP 1100 access point.

Step 1. Download the latest firmware.

Step 2. Once the firmware is downloaded, open a web browser such as Internet Explorer or Firefox and enter the IP address of the access point (default: 192.168.1.1).

Step 3. Enter username (admin) and password (admin). Click "OK" to enter the web configuration for the device.

Step 4. Click on the "Status" tab and check current firmware version/build date.

Step 5. Click on the "Administration" tab and then the "Firmware Update" link. Click on the "Browse" button and browse to the .bin file you downloaded in Step 1. Highlight the file by clicking on it once and click "Open."

Step 6. Click "Upgrade." It may take a up to 60 seconds for the upgrade to complete. IMPORTANT: DO NOT turn off device and DO NOT change the webpage until the firmware upgrade is completed.

Step 7. When firmware the upgrade is ready, the following page will be displayed on the screen. Click “Continue.”

Step 8. If you get a "page cannot be displayed" or similar error after clicking "Continue," close your browser and re-open it. Enter 192.168.1.1 and press "Enter." You should now be prompted for your username (admin) and your password (admin).

> Back to FAQ

 

Copyright ©2006 ArrowSpan, Inc. All rights reserved. Privacy Policy